The next generation of the Bren, the Bren 2 Ms makes first landfall in the US in pistol form with multiple barrel lengths and two chamberings. Whereas the 805 Bren was designed to a specific set of requirements set out by the Czech military, the Bren 2 is a clean-sheet design. With a bevy of changes, the most noticeable is sure to be the strict weight-loss regimen that the Bren 2 has undergone. With a trimmed-down aluminum receiver and a lower made from carbon fiber-reinforced polymer, the result is a robust but substantially lighter gun.
Gone is the reciprocating charging handle, replaced with one that stays stowed in the forward position until it is needed. Swappable from side to side, it does double duty as a forward assist. Also added is an AR-style bolt catch/release system that is mirrored on both sides of the firearm, as well as a catch/release nestled into the front of the trigger guard. The magazine release and safety are also ambidextrous and located in very familiar locations for anyone versed in the AR platform.
Chambered in 5.56 and 7.62×39, each is available in several barrel lengths. AR-15 style magazines are used for 5.56 variants, whereas in 7.62 the factory’s magazines are used to ensure last round hold-open and consistent feeding. All variants are swappable to different barrel lengths and chamberings and also feature a modular forend that can be swapped to different lengths.
The next generation of the Bren, the Bren 2 Ms makes first landfall in the US in pistol form with multiple barrel lengths and two chamberings. Whereas the 805 Bren was designed to a specific set of requirements set out by the Czech military, the Bren 2 is a clean-sheet design. With a bevy of changes, the most noticeable is sure to be the strict weight-loss regimen that the Bren 2 has undergone. With a trimmed-down aluminum receiver and a lower made from carbon fiber-reinforced polymer, the result is a robust but substantially lighter gun.
Gone is the reciprocating charging handle, replaced with one that stays stowed in the forward position until it is needed. Swappable from side to side, it does double duty as a forward assist. Also added is an AR-style bolt catch/release system that is mirrored on both sides of the firearm, as well as a catch/release nestled into the front of the trigger guard. The magazine release and safety are also ambidextrous and located in very familiar locations for anyone versed in the AR platform.
Chambered in 5.56 and 7.62×39, each is available in several barrel lengths. AR-15 style magazines are used for 5.56 variants, whereas in 7.62 the factory’s magazines are used to ensure last round hold-open and consistent feeding. All variants are swappable to different barrel lengths and chamberings and also feature a modular forend that can be swapped to different lengths.
For those who wish to SBR, the Bren 2 Ms comes with a flush rear plate that has the provision for attaching a AR-style buffer tube so a stock can be installed or the entire rear plate can be removed and replaced with a factory folding/adjustable stock.
FFL Restriction
You must be 18 years of age or older to purchase rifles and shotguns, and 21 or older to purchase handguns, receivers, frames, and suppressors. Minimum age requirements may vary by state. Check your state and local laws before ordering. It is your responsibility to fully understand the laws in your area and to ensure that possession of this item would not violate any applicable state or local laws. This product must be delivered to a Federal Firearms License holder.
WARNING: Cancer & Reproductive Harm - www.P65Warnings.ca.gov